Stainless Steel Round Bar | 17-4ph Stainless Steel | Custom Pump Shaft | Specialty Steel Supply

Current Location:Home » steel database » Steel standards » Tool Steels standards » ASTM A597 - 87(2010)

steel database category

Tel: 13880247006

E-mail:sales@steel0.com

ASTM A597 - 87(2010)

ASTM A597
Abstract

This specification covers tool steel compositions appropriate for usable shapes cast by pouring directly into suitable molds and for master heats for remelting and casting. Grades of the Tool steel covered in this specification include air- and oil-hardening grades such as CA-2, CD-2, CD-5, CM-2, CS-5, CS-7, CH-12, CH-13, and CO-1. The steel shall be made by one or more of the following processes: electric-arc furnace or induction furnace and may be argon-oxygen decarburization refined. Each of the steel shall undergo chemical analysis and shall conform to the chemical composition specification for carbon, manganese, silicon, sulfur, phosphorus, chromium, molybdenum, vanadium, cobalt, tungsten, and nickel. Material shall be packed and marked with heat or lot number, specification number, steel type, and form to ensure safe delivery and proper identification.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the Standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

 

1.1 This specification covers Tool steel compositions for usable shapes cast by pouring directly into suitable molds and for master heats for remelting and casting.

Note 1—A master heat is defined as any single heat of steel of certified analysis which has been processed into suitable form (shot, ingot, etc.) for remelting. A uniform blend of master heats is also acceptable for remelting. This blend is defined as a master heat lot and its average chemical composition shall be certified.


1.2 Nine grades, CA-2, CD-2, CD-5, CM-2, CS-5, CS-7, CH-12, CH-13, and CO-1, are covered in this specification.

Note 2—The committee formulating this specification has included air- and oil-hardening grades of Tool steel that have been extensively used. Other compositions will be considered for inclusion as the need arises.

 


2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the Standard.
ASTM Standards

A751 Test Methods, Practices, and Terminology for Chemical Analysis of steel Products
E59 Practice for Sampling steel and Iron for Determination of Chemical Composition


--------------------------------------------------------------------------------

Index Terms

 

Argon-oxygen decarburization (AOD) refined; Cast tool steel; Electric-arc furnace; Induction furnace; Tool steel--specifications ;

 

 

--------------------------------------------------------------------------------

ICS Code

 

ICS Number Code 77.140.80 (Iron and steel castings)

 

 

--------------------------------------------------------------------------------
DOI: 10.1520/A0597-87R10

ASTM International is a member of CrossRef.

 

--------------------------------------------------------------------------------

ASTM A597 (Steel Standards)
Citing ASTM Standards

 




[Back to Top]
1 Page